When using variables to set a trigger doesn't that isolate a button?
Here is what I'm doing, I set the side key on the treo to set the brightness to 255,
next I set an idle trigger to dim it back to 45 after 60 seconds.
What I would like to do is set a variable for the initial trigger a=0
Then set another variable for a second condition of the button a>0
So that if the screen is set to 255 and I press the side button again
I could disable the idle trigger. (Reading a document or web page, etc..)
However with the side key even with a variable set I can't select it again to run another macro.
So I'm guessing the variables are not taken into consideration when writing macros/triggers.
Is that correct?
Thanks,
Don